Issue link: http://fortsillfamilyandmwr.uberflip.com/i/855058
Match Rules Divisions Factory/Patrol: 3 FACTORY DIVISION: 3.1 FACTORY PISTOL 3.1.1 Firearms must function and operate as in the original factory configuration. 3.1.2 Internal and External modifications are allowed, provided the modifications do not alter the original function and operation of the firearm. 3.1.3 Firearms with custom or factory installed electronic sights, compensator or barrel porting are illegal in this division. 3.1.4 Pistol magazines shall not be loaded with more than fifteen (15) rounds after the start signal. However, a (15+1) magazine is legal to charge the chamber at the make ready command. 3.1.5 Pistol magazines used shall NOT exceed 171.25 mm OAL (overall length) for single stacks and shall not exceed 141.25 mm OAL for double stack or staggered magazines. Downloading magazines to fifteen (15) rounds is allowed. 3.1.6 Any Pistol Magazine failing to meet the provisions of (Rule 3.1.4 or Rule 3.1.5) after the competitor has completed one or more stages, will result in the shooter being moved into Unlimited Division. 3.1.7 The "Stage Ready Condition" for all pistols shall be magazine and chamber loaded and holstered, unless stipulated otherwise in the Written Stage Briefing. Multi-gun or Long Range: If the competitor opts to go prone at the start, then the pistol can be holstered, with loaded magazine inserted, with the chamber empty. 3.2 FACTORY RIFLE 3.2.1 Firearms must function and operate as in the original factory configuration. 3.2.2 Internal and external modifications are allowed, provided the modifications do not alter the original function and operation of the firearm. 3.2.3 Compensators are allowed in this division, provided the compensator is not larger than one (1") inch in diameter and three (3") inches long, measured from the barrel muzzle to the end of the compensator. 3.2.4 Factory Division rifles can be equipped with iron sights and or no more than one (1) non- magnified (1x) optical sight. Both sight systems can be used in conjunction, co-witnessed or offset. Illuminated "Red Dot" non magnified is acceptable. 3.2.5 All rifle magazines must be of a thirty (30) round factory configuration and must not exceed the original factory produced length. The use of factory or aftermarket extended base pads, that increase capacity is illegal. Magazine couplers that replace the floor plates without adding capacity and traditional magazine body style couplers are allowed. Downloading magazines with greater capacity than 30rds is illegal, but the use of lower capacity magazines is allowed. 3.2.6 Any Rifle Magazine failing to meet the provisions of (Rule 3.2.5) after the competitor has completed one or more stages, will result in the shooter being moved to Practical Division. Continued 5